Mixture Cable To Carburetor Lever Swivel Attachment - Cub Crafters CC18-180 Maintenance Manual

Refer to Figure 76-00-9
(a) The mixture cable is fastened to the mixture bracket clamp (7) with a bolt (6),
washers (5), and a nut (4).
(b) The mixture bracket (7) is secured to the engine mount with a bolt (1), a washer
(2), and a nut (3).
The position of the cable housing in the mixture bracket clamp (7) affects the
travel of the knob in relation to the instrument panel. The travel can be adjusted
by loosening the mixture bracket clamp (7) holding the cable housing and sliding
the cable housing in the clamp. Retighten the clamp and check travel.
(c) Be sure the cable housing is held tightly in the clamp after making any
adjustments.

(3) MIXTURE CABLE TO CARBURETOR LEVER SWIVEL ATTACHMENT

1- Cable Rod
2- Stud
3- Swivel
Figure 76-00-10 - Attachment of Mixture Cable to Carburetor Swivel Arm
76-00
Page: 10
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
4- Mixture Lever
5- Washer
6- Short Castellated Nut
7- Cotter Pin
Manual number TC10000AMM
Date: 05/20/08