Cub Crafters CC18-180 Maintenance Manual page 324

i.
j.
k. Makes sure the felt baffle seal is laying properly.
l.
1.2 WINTERIZATION KIT
1.2.1 INSTALLATION
This kit must be removed when the aircraft is operated above 40°F.
Service Letter SL0003 must be complied with prior to this installation.
a. Remove the top engine cowl, and remove the four bolts and hardware
b. Remove attachment bolts and support oil cooler. Do not disconnect oil
c. Install oil cooler plate (TC5021-001) in front of baffle, aligned with the four
d. Verify that 1.00"±.13 of the oil cooler is still exposed. Trim plate as
e. As required, install anti-chafe tape onto the exterior of the cowling to
f.
g. Install the cowl plates with (AN526C632R6), ensuring the flat side of the
h. Install SCAT tube (RM0006-001) between left cowl plate and flange on
i.
j.
k. Removal of oil cooler plate and cowl inlet plates is done opposite of
l.
m. Make a logbook entry each time kit is installed or removed.
71-10
Page: 4
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Install the air filter and dome (5) (Refer to 71-60 2.A.)
Double check to make sure all the hardware is tight.
Verify that there is equal clearance from the cowl on each side of the ring
gear and that the stiffeners are properly installed and not rubbing (8).
attaching the oil cooler to the engine baffles in accordance with the
instructions in Section 1.1.1.
lines.
bolt holes and oriented with the flat edge down. This should leave the
opening at the top. Reinstall the oil cooler and securely fasten with
previous hardware.
needed to achieve this.
prevent plate from rubbing.
Install SCAT Tube Flange (101889-01) on forward left baffle with screws
(AN526C632R7), washers (AN960-6L) and lock nuts (AN363-632).
cowl plates faces forward and the flange is at the top.
baffle with hose clamps (AN737TW74).
Reinstall top engine cowl per the instructions in Section 1.1.3.
Verify that there is a 2.75"± .13 gap from the top of the plates to the top of
the cowl inlets.
installation.
For subsequent operations in cold weather, repeat Steps a-h.
CAUTION
Manual number TC10000AMM
Date: 12/29/14