Cub Crafters CC18-180 Maintenance Manual page 297

(k) Press out the bullet at the wing to rear strut attachment point with the proper bolt.
Secure using the appropriate washer and nut. Torque to 160-190 in/lbs. (Reference
20-00.)
(l) Support the outboard end of the wing and remove the lower strut bullets. Insert the
proper bolts. Torque the nut to 36-48 in/lbs and safety with a cotter pin.
(m) Check the dihedral angle in accordance with Section B (Rigging the Wings). Adjust
if necessary.
(n) Check the wing washout in accordance with Section B (Rigging the Wings). Adjust
if necessary.
(o) Install the jury struts making sure the longer vertical tube is in front. The strut spacer
tube should have the longer slot aft. Secure using the appropriate bolt, washer and
nut then torque to 38-43 in/lbs.
(p) Reconnect the aileron crossover cable link (36) in the cabin.
(q) Connect the flap cable end to the bell crank link inside the wing with the proper bolt,
nut and cotter pin (38).
(r) Route the lower aileron cable down the strut.
(s) Install the associated pulley and fairleads. Make sure the cable is not hooked on a
strut or fuel tank strap stud (67).
(t) Connect the lower aileron control cables to the torque tube link or the upper aileron
horn. Ensure that the nuts have the appropriate cotter pins.
(u) Connect the pitot air tube at the wing root. Reconnect the antenna cables, stall
warning system, navigation and landing light wires at the wing root.
(v) Remove the tape from the fuel line ends and reconnect the fuel supply and gauge
lines (13, 16, 17, and 22) at the wing root. Torque the ¼ inch hose clamps to 10-14
in/lbs and the 3/8 hose clamps to 35-40 in/lbs.
(w) Ensure that the aileron cables are not rubbing or hung up. Check to verify the cable
tension is 40 ± 5 lbs. and if needed, adjust in accordance with Section 27-10
Ailerons.
(x) Install the wing pulley inspection plate covers (56).
(y) Attach the lower rear wing root fairing (10), the lower wing root fairing (5), the front
wing root fairing (3,), and the upper the wing root fairing (7).
(z) Install the fuel tank covers.
Manual number TC10000AMM
Date: 04/15/05
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
57-00
Page: 7