Cub Crafters CC18-180 Maintenance Manual page 258

(b) Install lock washer and nut.
(c) Connect wire to post light.
iii) INSTRUMENT LIGHTS
(1) GENERAL
(a) Instrument lighting is contained in either the gauge itself or a ring located
between the gauge and the panel. Contact CubCrafters for replacement.
iv) DOME LIGHT
(1) REMOVAL
(a) Remove (2) screws from the front frame.
(b) Remove (4) screws from the main body.
(c) Disconnect wiring from switch and remove light.
(2) INSTALLATION
(a) Reattach wiring.
(b) Install main light body.
(c) Install light frame.
v) MAP LIGHTS
(1) REMOVAL
(a) Disconnect LED harness.
(b) Remove nut and washer from outboard face of wing root panel.
(c) Remove map light from panel.
(2) INSTALLATION
(a) Install map light and washer.
(b) Attach washer and nut, locating panel between the (2) nylon washers. (Do not
over tighten to allow map light adjustment)
(c) Connect LED harness.
33-00
Page: 6
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Manual number TC10000AMM
Date: 05/21/14