Cub Crafters CC18-180 Maintenance Manual page 256

B. ANTI COLLISION
(1) GENERAL
(a) The anti collision beacon is a self-contained flashing light with a red and white
lens mounted on the top of the rudder. A breaker switch on the instrument panel
turns it on. For aircraft serial number 0056 and on and aircraft modified in
accordance with Service Letter 002 a portion of the red lens is masked. This part
must face forward.
(2) REMOVAL
(a) Loosen the plastic clamp at the base of light.
(b) Remove the lens.
(c) Remove the bulb.
(3) INSTALLATION
(a) Install the bulb, being careful not to bend or misalign the wire bulb contacts.
(b) Install the lens with the white half facing aft.
(c) Secure by tightening the clamp screw.
C. CABIN LIGHTING
(1) GENERAL
(a) Aircraft serial number 0056 and on and aircraft modified in accordance with
Service Letter 002 are equipped with interior lights for night VFR operations. The
interior contains lighting for fuel, placards, and instruments as well as a dome
light and two maps lights. The map lights and instrument lighting are on the same
circuit as the navigation lights. The intensity of the instrument lights may be
changed by means of two controls located on the instrument panel.
(b) The upper dimmers control:
33-00
Page: 4
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Large knob: The backlight to the digital readouts of the engine
instruments and placards.
Small Knob: The operational range LED lights on the perimeter of the
engine instruments, placards and emergency hand pump light (for
amphibious float option only).
c. The lower dimmer controls:
Large knob: Fuel sight gauges and map lights.
Small knob: Navigation instruments.
Manual number TC10000AMM
Date: 05/21/14