Cub Crafters CC18-180 Maintenance Manual page 255

(1) REMOVAL
(a) Remove lens trim strips.
(b) Remove 4 screws that hold the front mounting bracket.
(c) Disconnect wires from bulb and remove bulb.
(2) INSTALLATION
(a) Attach bulb to wires. On S/N 0056 and on, verify the polarity on LED lights is
correct.
(b) Reposition front mounting plate and secure with 4 screws.
(c) Reattach the lens and trim strips being very careful not to crack the Plexiglas.
A. NAVIGATION LIGHTS
(1) GENERAL
The colors of the navigation lights conform to standard aeronautical practice. The left
wing navigation light is red, the right wing navigation light is green and the tail
navigation light is white. A breaker switch on the instrument panel turns on all three
lights.
(2) REMOVAL
(a) Wing tip - Remove the light shield lens and turn the bulb a quarter turn to
unscrew. Be careful not to drop the glass lens or the gasket.
(b) Tail - Remove the lens retainer and lens and turn the bulb a quarter turn to
unscrew. Be careful not to drop the glass lens or the gasket.
Only approved navigation lights may be installed. The rudder navigation light affects the
balance of the rudder.
(3) INSTALLATION
(a) Wing tip - Insert the bulb and reinstall the lens and the shield.
(b) Tail - Insert a bulb and reinstall the lens and the lens retainer.
Manual number TC10000AMM
Date: 05/21/14
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
CAUTION
33-00
Page: 3