Installation And Removal; Lake And Air Amphibian Landing Gear Position Advisory System - Cub Crafters CC18-180 Maintenance Manual

CONFIGURATION
1
2

(2) INSTALLATION AND REMOVAL

(a) Install and remove floats in accordance with latest revision of Cubcrafters
drawing TC10200.
(b) Ensure that the changes are entered in the aircraft log book's weight and balance
section.
B. LAKE AND AIR AMPHIBIAN LANDING GEAR POSITION ADVISORY
SYSTEM
(1) ADJUSTMENT
There are only two adjustments: Volume and airspeed threshold. Both are located
on the side of the system controller unit. A small, flat-bladed screwdriver is required
to make the adjustments. The airspeed adjustment switch is found on the side of the
electronics box labeled "AIRSPEED."
 The airspeed threshold should be set to 65 mph (57 kts) minimum or 70 mph (61
kts) maximum.
 To increase the airspeed threshold, turn the switch clockwise and conversely.
 To lower the airspeed threshold, turn the switch counter-clockwise. The lowest
setting is 50 mph (43 kts) and increases in 5 mph (4.4 kts) increments at each
detent.
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
CONTROL PANEL
P/N
TC10701-001
TC10801-001
Table 32-60-2 - Instrument Panel Configuration
INSTALL PER
DRAWING
TC10700
TC10800
DETAIL
Round control panel
Square control panel
32-60
Page: 3