Cub Crafters CC18-180 Maintenance Manual page 243

2.2.3 INSTALLATION
See Figure 32-42-1
a. If the parking brake valve was separated from the master cylinder, apply a thin
coat of EZ TURN Lubricant to the threads on the front fitting. Tighten enough so
that it does not to leak but not so tight so as to break the nipple. The parking
brake handle and filler standoff must point up.
b. Reconnect the brake line (7) to the fitting on the bottom of the parking brake
valve (6) and tighten.
c. Reposition the master cylinder (5) against the base (4).
d. Reinstall the screws (1) with new lock washers (2) under the head through the
faceplate (3) into the base (4).
e. Rotate the cylinder (5) so that the vent/filler hole is pointed straight up.
f. Tighten the screws (1), in several steps to 28-32 in/lb. in an alternating pattern.
2.3 PARKING BRAKE VALVE
The parking brake valve locks the brake fluid pressure in the system. It is released when the
brakes by pressing the brake pedals or by moving the parking brake lever forward.
2.3.1 REMOVAL
See Figure 32-42-2
a. The parking brake valve (6) is attached to the master cylinder (5). Remove
master cylinder (5) as described in 32-42 2.B.(1).
b. Unscrew the parking brake valve (6) from the master cylinder (5).
2.3.2 INSPECTION
a. Visually check for damage or leaks. Replace if condition dictates.
2.3.3 INSTALLATION
a. Reinstall as described in 32-42 2.B.(3).
Manual number TC10000AMM
Date: 06/20/14
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
32-42
Page: 7