Cub Crafters CC18-180 Maintenance Manual page 193

PROBLEM
Tail Wheel Does Not Swivel
Tail Wheel Does Not
Absorb Shock
Brakes Drag
Brakes Inoperative
Manual number TC10000AMM
Date: 4/17/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
PROBABLE CAUSE
Fork Binds in Bracket
Because of Dirt or Lack of
Lubricant
Broken Leaf Spring
Tail wheel Tire Over Inflated Reduce Pressure to
Pressure Build Up In
System
Foreign Matter Wedged In
Brakes
Pistons Cocked In Cylinder
Piston Does Not Retract
Back Pressure Due To
Malfunction of Master
Cylinder or Parking Valve
Water or Ice In Hydraulic
System
Bent or Cracked Torque
Plate
Corroded Anchor Bolts
and/or Torque Plate
Bushings
Warped Brake Disc; Inspect
By Laying a Straight Edge
Across Disc Face
Out of Position/Stuck Lining
Restriction In Hydraulic Line
Lining Not Firmly Seated
Flush Against Pressure /
Back Plate
Brake Fluid Level Low
Air in Brake System
Worn Brake Linings
Defective Caliper
Defective Master Cylinder
Leaky Brake Line
Connections
REMEDY
Disassemble, Clean,
Reassemble, and Lubricate
Replace Leaf Spring
Recommended PSI.
Bleed Off Excess Pressure
Locate and Remove
Inspect Lining and/or Disc
For Wear and Replace as
Necessary
Remove Caliper and Inspect
Piston O-Ring and Cylinder
Bleed Hydraulic System
and/or Repair/Replace
Master Cylinder or Parking
Valve
Flush and Bleed Hydraulic
System (Thaw Ice First)
Replace
Clean and Lubricate or
Replace
Replace and Use Caution
During Operation To
Prevent Excessive Energy
Input Into Brake
Repair or Replace
Isolate and Remove
Restriction
Deburr Rivet Hole on
surface Adjacent to Lining
Replenish Brake Fluid
Bleed Brake System
Replace Linings
Replace Caliper
Replace Master Cylinder
Tighten or Replace
Connectors
32-00
Page: 3