Cub Crafters CC18-180 Maintenance Manual page 185

1. Detent Holes
2. Snap Ring
(e) Rotate the shaft so the detent balls (4) are between the detent holes (1).
(f) Remove the snap ring (2) holding the handle barrel (3) in the housing.
(g) Carefully pull the barrel (3) out of the housing with your fingers positioned to
catch each set of balls and springs (4).
(h) Remove the small O-ring (5) and the large O-rings (6) then clean the barrel.
(i) Inspect for wear and grooves.
(j) Replace the small O-ring (5) and the large O-rings (6) with new and lube on
installation.
(k) Insert the barrel (3) part way in the housing.
(l) One set at a time, insert a spring with a ball (4) on each end and push the barrel
the rest of the way in.
(m) Secure with the snap ring (2).
Manual number TC10000AMM
Date: 01/10/06
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
3. Barrel
4. Detent Balls and Springs
Figure 28-00-5 - Fuel Selector Detail
5. Small O-Ring
6. Large O-Rings
28-00
Page: 9