Rigging The Position Of The Flaps - Cub Crafters CC18-180 Maintenance Manual

Reference Figure 27-50-3
(d) At the inboard hinge (2 Figure 27-50-2) insert a hinge pin (a), pointing inboard,
through the hinge (e), spacer washer (b) hinge bracket (f), spacer washer (b),
hinge (e) and washer (c) Secure with a cotter pin (d).
(e) At the outboard hinge (1 Figure 27-50-2) fill any gap between the hinge (e) and
hinge bracket (f) with a thin or thick spacer washer as necessary.
(f) Insert a hinge pin (a), pointing inboard, through the hinge (e), hinge bracket (f),
hinge (e) and washer (c). Secure with a cotter pin (d).
(g) At the inboard hinge (2 Figure 27-50-2) align the flap control rod ball end (C
Figure 27-50-1) with the hinge (B Figure 27-50-1) attach point.
(h) Insert the bolt (A Figure 27-50-1) through the hinge (B) and ball end (C Figure
27-50-1) then secure with a washer (E Figure 27-50-1) and nut (F Figure 27-50-
1) torqued to 38-43 in/lbs.
It may be necessary to check the flap rigging depending on the parts that were

(3) RIGGING THE POSITION OF THE FLAPS

(a) Position the flaps in the "UP" position.
(b) Place a straightedge along the bottom of the wing at a position mid span along
the flap. The bottom surface of the flap should line up with the bottom of the
wing.
(c) To adjust, unbolt the flap actuator rod ball end from the flap hinge. Loosen the
jam nut (D Figure 27-50-1) and screw the ball end (C Figure 27-50-1) in or out
accordingly. Ensure that both flaps are aligned.
27-50
Page 4
CUB CRAFTERS
CC18-180 MAINTENANCE MANUAL
removed.
NOTE
Manual number TC10000AMM
Date: 4/15/05