General; Maintenance Practices; Removal - Cub Crafters CC18-180 Maintenance Manual

1. GENERAL

The flaps are operated mechanically by moving a lever located on the left forward side of the
cockpit. The flaps are slotted and have three positions, up, first notch, (22º) and full flaps (50º).
The flap lever has a spring latch system that holds the flap in the selected position.

2. MAINTENANCE PRACTICES

(1) REMOVAL

A- Bolt
B- Hinge
(a) Remove the bolt holding the flap control rod ball end (C) at the hinge (B) (Figure
27-50-1)
(b) Remove the hinge pins (Figure 27-50-2) and carefully separate the flap.
27-50
Page 2
CUB CRAFTERS
CC18-180 MAINTENANCE MANUAL
C- Ball end E- Washer
D- Jam nut F- Nut
Figure 27-50-1 - Flap Actuator
G- Actuator rod
Manual number TC10000AMM
Date: 4/15/05