Cub Crafters CC18-180 Maintenance Manual page 167

Figure 27-40-9 - Attachment of Strakes - LH Shown
Refer to Figure 27-40-8
(1) TAIL STRAKE REMOVAL
(a) Remove the inspection covers that are located under the tail.
(b) Remove the lower attachment screws, washers, and nuts from the strakes on
one side.
(c) Remove the upper attachment screws.
(d) Repeat on the opposite side.
(2) INSTALLATION
(a) Attach strake with the 4 upper attachment screws.
(b) Install the 2 lower attachment screws, washers and nuts. Add or remove washers
to ensure that the horizontal surface of the strake is parallel to the stabilizer.
(c) Repeat for the strake on the opposite side.
(d) Install the inspection covers.
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Upper Attach Screws
Lower Attach
Screws
27-40
Page: 13