(4) Stretch the indicator wire and secure it to the plate that attaches the indicator button
ensuring that it remains aligned with the setsquare. (Note: over the course of a few
days, the wire may uncoil after installation and the indicator may have to be re-set).
(5) Ensure that the shaft is centered in the hole and that the plate is square with the
longeron (step 3) and install the cover plate.
(6) Check that the indicator button, the center mark on the scale and the shaft are in line
and perpendicular to the main longeron tube on the left side of the fuselage. Ensure
that the indicator button is able to travel through the full range without contacting slot.
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Datum
Figure 27-40-6 - Alignment of Indicator Button
27-40
Page: 11