Cub Crafters CC18-180 Maintenance Manual page 164

(2) Turn the rear stabilizer pulley until it is centered on the jackscrew (± 0.063 or 1/16
inch). Centering can be done by measuring with a ruler or by counting the turns of
the trim handle.
Figure 27-40-5 - Yoke in the Center of the Jackscrew
(3) Position the indicator button to line up with a square placed on the bottom of the
main longeron tube on the left side of the fuselage or on the bottom of the throttle
quadrant; the set square must line up with the center of the trim handle shaft (Figure
27-30-6).
27-40
Page: 10
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Manual number TC10000AMM
Date: 05/20/08