Cub Crafters CC18-180 Maintenance Manual page 161

Refer to Figure 27-40-3
(a) Set the tail of the aircraft on a sawhorse or a bench.
(b) Position a long tail wire with the most sharply bent clevis (1) on the fin and insert
a bolt (3) with a bent washer (4).
(c) On the opposite side of the fin, install the other long tail wire with the most
sharply bent clevis (1) at the top; insert the bolt and secure with a bent washer
(4) and nut (5) and torque to 80-100 in/lbs.
(d) Line up the clevis (1) that is on the lower end of a long wire with the hole in the
rear spar of the horizontal stabilizer.
(e) Insert a bolt (6) with a washer (7) and bushing (8) through the clevis (2).
(f) Position a short tail wire, with the bent clevis (2) through the bolt that was just
inserted through the rear spar of the horizontal stabilizer. Secure with a washer
(9), bushing (8) and nut (10) and torque to 38-43 in/lbs.
(g) Line up the clevis (2) on the lower end of the wire with the hole in the tab that is
on the bottom, rear end the fuselage (12). Be sure that the tab on the fuselage
(12) is sandwiched between the two surfaces of the clevis (2).
(h) Insert a bolt (11) and secure with a washer (9) and nut (10) and torque to 38-43
in/lbs.
(i) Repeat on the opposite side.
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
27-40
Page: 7