Installation - Cub Crafters CC18-180 Maintenance Manual

Refer to Figure 27-30-1
(1) Remove left hand and right hand tail inspection covers.
(2) Loosen the bolt (5) on the top side of the upper link forward and remove the top bolt
(9).
(3) Pivot the upper link forward to remove the cable tension.
(4) Remove the bolts (5) to disconnect the upper link from the elevator horns.
(5) Remove the rear screw (1) to disconnect lower link from the elevator horns.
(6) Remove the hinge pins, one side at a time, and carefully separate the elevators from
the stabilizer and fuselage.
B. INSTALLATION
(1) Identify which are the left and right elevators. The sewn seams are on the bottom
trailing edge of each.
Figure 27-30-2 - Clevis Pin Installation on Elevator
(2) Install each elevator onto the matching hinges on the stabilizers using (1) clevis pins
with a (2) washer at each end of every pin, and then secure each with (3) two cotter
pins. (Figure 27-30-2)
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
3
`
2 1
` `
27-30
Page: 3