Rigging - Cub Crafters CC18-180 Maintenance Manual

I - Cable Fitting
II - Clevis Screw
Figure 27-20-3 - Attachment of Rudder Cable Fitting
(4) Hook each tail wheel steering spring (1) to a rudder arm. Lubricate the hinge pins
and pivot points with LPS-2 oil.
(5) Install the rectangular inspection cover.
C. RIGGING
(1) Check that the rudder is centered when rudder pedals are inline with each other.
Ensure that the rudder can travel through its full range, left and right. Rudder travel
may be measured using a special protractor available at Cub Crafters for a nominal
fee. The travel is not adjustable on the field. Contact Cub Crafters if adjustments to
the travel are required. Make any adjustments at the rear cable attach fitting (I Figure
27-20-3) by changing the hole through which the screw (II Figure 27-20-3) goes
through to the fitting (I Figure 27-20-3). Safety each nut (IV Figure 27-20-3) with a
cotter pin (V Figure 27-20-3).
(2) Make sure all castellated nuts and clevis pins are secured with cotter pins.
27-20
Page: 4
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
III - Thin Washer
IV - Castle Nut
V - Cotter Pin
Manual number TC10000AMM
Date: 05/20/08