Installation - Cub Crafters CC18-180 Maintenance Manual

Refer to Figure 27-20-1
(1) Unhook the tail wheel steering springs from the rudder arm (1).
(2) Disconnect the rudder cables (2) from the rudder horn.
(3) Remove the rectangular inspection cover and disconnect the electrical wiring to the
tail assembly (3).
(4) Remove the hinge pins (4) and separate the rudder assembly from the fin.
B. INSTALLATION
Figure 27-20-2 - Installation of Clevis Pins at Rudder Hinges
(1) Position the rudder hinges inline with the hinges on the fin and fasten with 2 clevis
pins (A), washers (B) and cotter pins (C). (Figure 27-20-2)
(2) Reconnect the electrical wiring to the lights in the light (3).
(3) Secure each rudder cable fitting (I Figure 27-20-3) to a rudder horn (1) with a screw
(II Figure 27-20-3), washer (III Figure 27-20-3) and nut (IV Figure 27-20-3). Make
certain that the connections pivot freely and that the rudder is centered when rudder
pedals are inline with each other. Verify that full rudder travel to the left and to the
right can be obtained. Make any adjustments at the rear cable attach fitting (I Figure
27-20-3) by changing the hole through which the screw (II Figure 27-20-3) goes
through the fitting (I Figure 27-20-3). Safety each nut (IV Figure 27-20-3) with a
cotter pin (V Figure 27-20-3).
Manual number TC10000AMM
Date: 05/20/2008
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
A
B
C
27-20
Page 3