Balancing - Cub Crafters CC18-180 Maintenance Manual

(i) File off face of lower stop tube until 0 to 1/8 inch clearance is obtained between
the aileron horn and lower stop tube with aileron in the full down position.
(j) Drill through the stop bracket and into one side of the aileron hinge bracket with
a #40 drill.
(k) Lock the stop bracket in position with a screw (4).
(l) Repeat on the opposite side.
Tight cables make stick action stiff while loose cables result in stick action that is too free and
uncertain. Properly adjusted cables should not slap or wobble when the stick is moved back and

3. BALANCING

A.
PROCEDURE
(1) Insert a 0.25" pin or bolt through each of the outboard hinge holes of the aileron (2
per aileron) such that about 0.25" of the pin or bolt protrude from either side of the
hinge.
27-10
Page: 8
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
Figure 27-10-10 - Lower Aileron Stop
NOTE
forth in rapid succession.
Manual number TC10000AMM
Date: 05/20/08