C. RIGGING
(1) PROCEDURE
Figure 27-10-4 - Alignment of Aileron Trailing Edge with Flap Trailing Edge
(a) The neutral position of the ailerons is found by matching as closely as possible,
the trailing edge of the ailerons with the trailing edge of the flaps and the wing tip
ribs.
.
Figure 27-10- 5 - Alignment of Aileron Trailing Edge with Wing Tip
(b) The ailerons must be rigged so that the top aft edge of the outboard end rib of
either aileron does not extend more than 1/4-inch above or 1/4-inch below the
top aft edge of the end wing rib with the control stick deflected right 1º ± 1º of
vertical. (See Figure 27-10-5)
(c) To raise the trailing edge of an aileron, take up the turnbuckle at the upper
aileron horn and simultaneously let out the turnbuckle at the lower aileron horn.
(d) The aileron trailing edge may be lowered by reversing the procedure. Ensure
that the cable tension is 40 ± 5 lbs. (Refer to 06-00).
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
27-10
Page: 5