Troubleshooting - Cub Crafters CC18-180 Maintenance Manual

3. TROUBLESHOOTING

PROBLEM
Control Sticks are Displaced
When Ailerons are in Neutral
Improper Aileron Travel
Lost Motion in Control Sticks
Excessive Resistance To
Movement of Control Sticks
Full Elevator Travel Cannot
Be Achieved
Stabilizer Does Not Move Up
or Down When Actuating
Stabilizer Adjustment Crank
Stabilizer Moves Only With
Excessive Resistance
Manual number TC10000AMM
Date: 05/20/08
CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
PROBABLE CAUSE
Control Cables Improperly
Rigged
Control Cables Improperly
Rigged
Torque Tube Incorrectly
Adjusted
Loose Control Cables
Broken Pulley
Worn Holes in Control Stick
Stub or Torque Tube Where
They Attach to Each Other
Control Cables too Taut
Pulleys Binding
Pulleys Binding
Control Cable Slips on Pulleys
Because of Oil or Grease
Broken Control Cables
Loose Control Cables or
Springs
Broken or Worn Pulley
Stabilizer Adjustment Screw
Sheared
Pulleys Binding
Cable Guide Block Damaged
or Misaligned
Indicator Wire Pulleys
Damaged or Broken
Screw and Yoke Assembly
Jammed
Tube Frozen to Link Assembly
REMEDY
Adjust Control Cables
Adjust Control Cables
Readjust Torque Tube
Take Up Slack on Control
Cables
Replace Broken Pulley
Replace Worn Control Stick
Stub or Torque Tube
Adjust Control Cables
Replace Damaged Pulleys
Replace Damaged Pulleys
Clean Oil or Grease From
Cable Cloth Moistened in
Clean Gasoline
Replace Broken Control
Cable
Replace Weak/Broken
Spring
Replace Pulley
Replace Stabilizer
Adjustment Screw
Replace Damaged Pulleys
Realign or Replace
Damaged Cable Guide Block
Replace Broken or
Damaged, Indicator Wire
Pulleys
Disassemble, Clean, and
Reassemble Screw, and
Yoke Assembly
Disassemble, Clean, and
Reassemble Tube to Link
Assembly
27-00
Page: 3