CUB CRAFTERS, INC.
CC18-180 MAINTENANCE MANUAL
4. USE OF TORQUE WRENCHES AND ADAPTORS
All final torquing shall be carried out with certified torque wrenches or torque screwdrivers.
When adaptors or extensions are used on manually operated torque wrenches, they shall be
aligned as shown in Figure 20-00-1 and the dial reading required shall be calculated from the
following formula:
Dial Reading = Specified Torque X L
L+L
1
Dimensions must be measured in the same units (i.e. both in inches, both in feet etc.) for each
calculation. Different units must not be mixed.
20-00
Manual number TC10000AMM
Date: 05/20/08
Page: 3