Power Connector Cable - HP 15 TouchSmart Notebook PC Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Keyboard (see
●
Top cover (see
●
Display (see
To remove the power connector cable:
1. Position the computer upright.
2. Remove the two Phillips PM2.5×5.0 screws (1) that secure the cable to the computer.
3. Disconnect the power connector cable (2) from the system board.
4. Release the power connector cable from the clips (3) built into the chassis.
5. Remove the power connector cable (4).
Reverse this procedure to install the power connector cable.
Battery on page 35), and then remove the following components:
Keyboard on page 39)
Top cover on page 47)
Display assembly on page 70)
Component replacement procedures
Spare part number
749647-001
59