Table of Contents
Advertisement
4.
Disconnect the speaker cable (4) from the system board.
5.
Remove the two Philllips PM2.5×3.7 broad head firmware screws (1) that secure the system board to
the base enclosure.
IMPORTANT:
These screws have specific properties that ensure the proper operation of the computer.
6.
Remove the four Philllips PM1.9×4.2 screws (2) that secure the system board to the base enclosure.
40
Chapter 5 Removal and replacement procedures
The firmware screws must be installed in the locations shown in the following image.
Hide quick links:
Advertisement
Table of Contents
