HP Chromebook 11-2100 Maintenance And Service Manual page 32

Before removing the keyboard/top cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the 2 rear computer feet (see
NOTE: When replacing the keyboard/top cover, be sure that the heat sink (see
TouchPad (see
installed on the replacement keyboard/top cover.
Remove the keyboard/top cover:
1. Remove the two rubber screw covers (1).
NOTE:
●
762581-001–For use only on HP Chromebook 11-21xx computer models in ocean turquoise finish
●
762583-001–For use only on HP Chromebook 11-21xx computer models in snow white finish
●
762582-001–For use only on HP Chromebook 11-21xx computer models in sweet yellow finish
●
773211-001–For use only on HP Chromebook 11 G3 computer models
2. Remove the eleven Phillips PM1.9×6.7 screws (2) that secure the keyboard/top cover to the
base enclosure.
3. Turn the computer right side up with the front toward you.
4. Open the computer as far as it will open.
5. Lift the front edge (1) of the keyboard/top cover until it separates from the front edge of the
base enclosure.
26 Chapter 5 Removal and replacement procedures
TouchPad board on page
The rubber screw covers are included in the Rubber Kit, spare part numbers:
Computer feet on page
32) are removed from the defective keyboard/top cover and
24).
Heat sink on page 31) and