Table of Contents
Advertisement
Reverse this procedure to install the power connector cable.
Display assembly
NOTE:
The display assembly is spared at the subcomponent level only. For more display assembly spare
part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the Battery (see
a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
f.
Speakers (see
g.
System board (see
Remove the display assembly:
1.
Release the display panel cable from the routing clips (1) and channel built into the base enclosure.
2.
Release the wireless antenna cables from the routing clips (2) and channel built into the base enclosure.
3.
Remove the three Phillips PM2.5×4.5 screws (1) that secure the display assembly left hinge to the
base enclosure.
Battery on page
29), and then remove the following components:
Service cover on page
Hard drive on page
31)
Optical drive on page
Keyboard on page
38)
Top cover on page
41)
Speakers on page
49)
System board on page
30)
37)
52)
Component replacement procedures
63
Advertisement
Table of Contents
