Table of Contents
Advertisement
Fingerprint reader module
Description
Fingerprint reader module (includes cable and double-sided adhesive)
Before removing the fingerprint reader module, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the Battery (see
a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the fingerprint reader module:
1.
Turn the top cover upside down with the front toward you.
2.
Release the ground tape (1) that secures the fingerprint reader module to the top cover.
3.
Detach the fingerprint reader module cable (2) from the top cover. (The fingerprint reader module cable
is attached to the top cover with double-sided adhesive.)
4.
Remove the fingerprint reader module (3) and cable.
Reverse this procedure to install the fingerprint reader module.
Battery on page
29), and then remove the following components:
Service cover on page
Hard drive on page
31)
Optical drive on page
Keyboard on page
38)
Top cover on page
41)
30)
37)
Component replacement procedures
Spare part number
746668-001
45
Advertisement
Table of Contents
