Getting Started - Quick Install & Test - Algo 8188 Installation/Configuration Manual

Getting Started - Quick Install & Test
This guide provides important safety information which should be
read thoroughly before permanently installing the speaker.
1. Connect the 8188 SIP Ceiling Speaker to an IEEE 802.3af compliant
PoE network switch. The blue LED will remain on until boot up is
completed – about 30 seconds.
2. After the blue LED turns off, press the reset switch (RST) to hear the
IP address over the speaker. The IP address may also be discovered
by downloading the Algo locator tool to find Algo devices on your
network:
3. Mount the speaker per the instructions in this guide.
4. Access the 8188 Ceiling Speaker web page by entering the IP address
into a browser (Chrome, IE, Firefox etc) and login using the default
password algo.
5. Enter the IP address for the SIP server into the SIP Domain field
under the BASIC SETTINGS > SIP tab.
6. Enter the page SIP extension and password. (Note the speaker
supports two SIP extensions. The page extension auto-answers for
paging. The ring extension plays a WAV file over the speaker without
answering.)
7. Make a call to the speaker by dialling the page SIP extension from a
telephone. The speaker should auto-answer, play the default pre-
announce WAV file, and open a speech path.
8. Carefully install the protective grill working around the grill until fully
installed and flush with the housing.
Document 90-00067 A
2014-09-12
Page 7
www.algosolutions.com/locator
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com