Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Function Remotes - Craftsman 139.53990DS Owner's Manual

PROGRAMMING
NOTICE: ff this Security÷_ garage door opener is operated with a non-rolling code transmitter, the technical measure in the
receiver of the garage door opener, which provides security against code-theft devices, wifl be circumvented. The owner of
the copyright in the garage door opener does not authorize the purchaser or suppfier of the non-rolling code transmitter to
circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The
door witl open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷_" remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE "LEARN" BUTTON USING THE MOTION DETECTING
CONTROL CONSOLE
1. Press and release the "learn" button
on the motor unit. The learn
indicator light witl gtow steadily for
30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your
garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button on
the Motion Detecting Control
Console.
3. Continue holding both buttons while
you press the push bar on the
Motion Detecting Control Console
(all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code.
If light bulbs are not installed, two
clicks will be heard.
\l/
To Erase All Codes From Motor Unit
Memory
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased. Reprogram each remote
or keyless entry you wish to use.
*3-Function Remotes
If provided with your garage door opener, the large
button is factory
programmed to operate it. __ Additional buttons on any
Security÷ <_,'
3-Function remote or
compact remote can be
programmed to operate
other Security÷ _,' g arage door openers.
35