Craftsman 139.53990DS Owner's Manual page 24

ONE-PIECE D OORS
Please readandcomply withthewarnings a nd
reinforcement instructions ontheprevious page. T hey
applytoone-piece d oorsalso.
• Center t hedoorbracket o nthetopofthedoor,in line
withtheheader b racket a sshown.Mark eitherthe left
andright,or thetopandbottom holes.
•
Metal Doors: Drill 3/16" pilot holes and fasten the
bracket with the 1,/4"-14x5/8" self-threading screws
provided.
• Wood Doors: Drill 5/16" holes and use 5/16"x2"
carriage bolts, lock washers and nuts (not provided) or
5/16"x1-1/2" lag screws (not provided) depending on
your installation needs.
HARDWARE SHOWN
ACTUAL SiZE
Self-Threading Screw
1/4"-14x5/8"
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation. (Refer
to the dotted line optional placement drawing.)
Header Wall
2x4 Support
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
HORIZONTALAND VERTICAL
REINFORCEMENTIS NEEDED
FORLiGHTWEiGHT GARAGE
DOORS(FIBERGLASS, ALUMINUM, ;
STEEL, DOORS WiTH GLASS
PANEL, ETC.). (NOT PROVIDED)
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
Door
'_ Self-Threading
- Screw
_ 1/4"-14x5/8"
Top of Door
of Door
Optional
Placement
METAL DOOR
Nut _ Lock
5/16"-18 --_ _ Washer
, 5/16"
i
i
i i
Top of Door
(Inside Garage)
Top Edge
of Door
Optional
Placement
Carriage Bolt
_ b 5/16"x2"
(Not Provided)
WOOD DOOR
24