Troubleshoot With The Leds; Standard Led Behavior When The Router Is Powered On; Power Led Is Off Or Blinking; Power Led Stays Amber - NETGEAR Nighthawk R6700 User Manual

Troubleshoot with the LEDs

By default, the router is set with standard LED settings. If you disabled blinking for the LEDs
or turned off all LEDs except the Power LED, you must return the LEDs to their standard
settings for troubleshooting. For information about controlling the LED settings, see
LED Blinking or Turn Off LEDs

Standard LED Behavior When the Router Is Powered On

After you turn on power to the router, the following sequence of events occurs:
1. When power is first applied, verify that the Power LED
2. After approximately 30 seconds, verify the following:
• The Power LED is solid white.
• The Internet LED is lit.
• The WiFi LED is lit unless you turned off the wireless radio.
You can use the LEDs on the front panel of the router for troubleshooting.

Power LED Is Off or Blinking

Is the Power LED is off or blinking, try the following:
• Make sure that the power adapter is securely connected to your router and securely
connected to a working power outlet.
• Check that you are using the power adapter that NETGEAR supplied for this product.
• If the Power LED blinks slowly and continuously, the router firmware is corrupted. This
can happen if a firmware upgrade is interrupted or if the router detects a problem with the
firmware. If the error persists, a hardware problem exists. For recovery instructions, or
help with a hardware problem, contact technical support at

Power LED Stays Amber

When the router is powered on, the Power LED lights amber for about 20 seconds and then
lights white. If the LED does not turn white, the router is experiencing a problem.
If the Power LED is still amber one minute after you turn on power to the router, do the
following:
1. Turn off the power and then turn it back on to see if the router recovers.
2. Press and hold the Reset button to return the router to its factory settings.
See Factory Settings
If the error persists, you might be experiencing a hardware problem. Contact technical
support at www.netgear.com/support.
Nighthawk AC1750 Smart WiFi Router
on page 104.
on page 178.
Troubleshooting
169
Disable
is lit.
www.netgear.com/support.