Table of Contents
Advertisement
Quick Tips
See the following for tips for troubleshooting some common problems:
•
Sequence to Restart Your Network
•
Check Ethernet Cable Connections
•
Wireless Settings
•
Network Settings
Sequence to Restart Your Network
When you must to restart your network, follow this sequence:
1.
Turn off and unplug the modem.
2.
Turn off the router.
3.
Plug in the modem and turn it on. Wait two minutes.
4.
Turn on the router and wait two minutes.
Check Ethernet Cable Connections
If your device does not power on, make sure that the Ethernet cables are securely plugged
in. The Internet LED on the router is lit if the Ethernet cable connecting the router and the
modem is plugged in securely and the modem and router are turned on. If one or more
powered-on computers are connected to the router by an Ethernet cable, the corresponding
numbered router LAN port LEDs light.
Wireless Settings
Make sure that the wireless settings in the computer and router match exactly. The wireless
network name (SSID) and wireless security settings of the router and wireless computer must
match exactly.
If you set up an access list in the Advanced Wireless Settings screen, you must add each
wireless computer's MAC address to the router's access list.
Network Settings
Make sure that the network settings of the computer are correct. Wired and wirelessly
connected computers must use network (IP) addresses on the same network as the router.
The simplest way to do this is to configure each computer to obtain an IP address
automatically using DHCP.
Some cable modem service providers require you to use the MAC address of the computer
initially registered on the account. You can view the MAC address in the Attached Devices
screen.
Nighthawk AC1750 Smart WiFi Router
on page 168
on page 168
on page 168
on page 168
Troubleshooting
168
Hide quick links:
Advertisement
Table of Contents
