I-Command Harness Connections With Mechanical Remote Control - BRP Evinrude Installation Manual

I-Command Harness Connections With Mechanical Remote Control

Typical I-Command wiring with a binnacle-mount mechanical remote control
1. I-Command Ignition and Trim Harness
2. I-Command Network Harness
3. 6-Pin Connector – Connect to a pre-wired remote control or to a dash-mounted key switch.
4. 3-Pin Connector – Connect to remote control trim switch or to a dash-mounted trim switch.
5. Purple, black wires – Connect to network power supply.
6. 4-Pin Amp Connector – Connect to outboard EMM.
1
6
BUSS BUSS BUSS
2
INFORMATION DISPLAY SYSTEMS
3
4
3A
5
BUSS BUSS
BOAT RIGGING
30 20
40 15
20 10 25
50
30
10 5
60
35
0
0
x 100 Water
70 40
RPM MPH
3550 15.2
M E N U M E N U
BUSS BUSS BUSS BUSS BUSS BUSS BUSS BUSS BUSS BUSS
EP- 85 Memory Module
007990
13
1