Confirming Or Selecting The Test Strip Lot - Accu-Chek Inform II Operator's Manual

Patient Glucose Testing
Confirming or selecting the test
strip lot
44
Once you have entered and confirmed the patient ID, you
are asked to choose the lot number for the test strips.
Compare the number displayed by the meter to the
number on the label of the test strip vial.
1 Select the lot number as follows:
To read the lot number from the test strip vial via
n
barcode scanner, press and release
the instructions for scanning IDs (see note below).
To use the preselected lot number displayed by the
n
meter, touch
To use a different lot number than the one
n
displayed, touch
numbers. Select the desired lot number from the
list.
2 Touch to confirm the selected test strip lot
number.
The meter can be configured so that manual
confirmation is not necessary. In this setup, only the lot
number is displayed. Additional options are not
available.
The meter can be configured so that lot numbers are
entered via barcode scanner only (see note below).
For additional information about storing lot numbers for
test strips, see page 65.
Note: Barcodes on test strips vials/control solutions
may not be available in all countries. In this case either
manually enter the lot number each time
n
(recommended),
pick a previously entered lot number from the list,
n
or
configure the meter to only display the lot number
n
(without confirmation by the operator).
to confirm.
to display a list of stored lot
. Follow