Assembling The 499Kl Scale (Refer To Figures 1 - Health O Meter 499KL User Instructions

499KL ASSEMBLY INSTRUCTIONS (CONTINUED)

Assembling the 499KL Scale (Refer to Figures 1 - 8)

Caution: It is recommended that the assembly be performed by two persons.
1. Carefully remove the scale platform and columns A and B from the carton. Place the scale
platform and columns on a flat, level, and dry surface (see Figure 1).
2. Remove the 4 small screws and washers from the bottom of column B (see Figures 1 & 2).
3. Locate cable connector inside column A (see Figures 1 & 3).
4. While holding column A, slide the cable connector through the top of column B. The top of
column B has a notch (see Figures 1 & 5).
5. Plug the cable connector into the RJ jack, located on the scale platform C
Note:
Ensure that the cable connector is correctly plugged into the RJ jack.
6. Align column A and column B, and ensure that the locking tabs are locked securely into place
(see Figures 1 & 5).
7. Position and secure the connected columns A and B to the scale platform C.
8. Insert the 4 small screws through the bottom of the scale platform C holes and into column B.
Ensure that washers are located between the screw heads and the scale platform holes (see
Figures 1, 6, & 7).
9. Using a Phillips head screwdriver, tighten the screws to secure column B to the base of the
scale platform C (see Figure 1, 6, & 7).
Note:
Ensure that the screws are fully tightened to prevent damage to the scale.
10. The scale is now assembled and ready for use (see Figure 8).
8
see Figures 1 & 4).
(