Ncu Parameters - Ricoh D158 Service Manual

Lanier, ricoh, savin

Table of Contents

NCU Parameters

4.8 NCU PARAMETERS

The following tables give the RAM addresses and the parameter calculation units that the

machine uses for ringing signal detection and automatic dialing. The factory settings for each

country are also given. Most of these must be changed by RAM read/write (SP2-101), but some

can be changed using NCU Parameter programming (SP2-103); if SP2-103 can be used, this will

be indicated in the Remarks column. The RAM is programmed in hex code unless (BCD) is

included in the Unit column.

The following addresses describe settings for the standard NCU.

Country/Area code for NCU parameters

Use the Hex value to program the country/area code directly into this

address, or use the decimal value to program it using SP2-103-001

South Africa

Table of Contents