Cannot Send By Alias Fax Number - Ricoh D158 Service Manual

Cannot send by Alias Fax number.

Check Point
1 LAN cable connected?
2 Number of specified Alias fax correct?
3 Firewall/NAT installed?
4 Transmission sent manually?
Gatekeeper/SIP server installed
5
correctly?
Gatekeeper/SIP server power switched
6
on?
IP address/host name of Gatekeeper/SIP
7
server correct?
DNS server registered when
8 Gatekeeper/SIP server host name
specified?
Enable H.323/Enable SIP SW is set to
9
on?
10 IP address of local fax registered?
11 Alias number of local fax registered?
12 Remote fax registered in Gatekeeper?
13 Remote fax a T.38 terminal?
14 Remote fax switched off or busy?
15 Network bandwidth too narrow?
16 Remote fax cancelled transmission?
SM
Action
Check the LAN cable connection.
Confirm the Alias of the remote fax.
Error Code: 13-14
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
Manual sending not supported.
Contact the network administrator.
Contact the network administrator.
Check the IP address/host name.
Contact the network administrator.
Check the settings.
See User Parameter SW 34 Bit 0/SW
34 Bit 1
Register the IP address of the local fax.
Register the Alias number of the local
fax.
Contact the network administrator.
Check whether the remote fax is a T38
terminal.
Contact the network administrator.
Request the system administrator to
increase the bandwidth.
Raise the delay level.
IPFAX SW 01 Bit 0 to 3
Lower the modem transmission baud
rate.
IPFAX SW 05
Check whether the remote fax
cancelled the transmission.
45
IP-Fax Troubleshooting
D702