Input Check Table For Copier (D158/D159) - Ricoh D158 Service Manual

Input Check Table for Copier (D158/D159)

-Conducting an Input Check -
1. Select SP5-803.
2. Select the number (see the table below) corresponding to the component.
3. Select "Execute." The copy mode is activated.
4. Either "01H" or "00H" appears (see the table below).
Num. Sensor/Switch
001 Tray 1: Paper Size Sensor
002 Tray 2: Paper Size Sensor
003 Tray 1: Tray Set Sensor
004 Tray 2: Tray Set Sensor
009 Tray 1: Paper End Sensor
010 Tray 2: Paper End Sensor
011 Tray 1:Paper Lift Sensor
012 Tray 2: Paper Lift Sensor
015 By-pass: Paper Size Sensor
016 By-pass: Paper End Sensor
017 By-pass: Paper Length Sensor
018 By-pass: Home Position Sensor Lowered
019 Paper Exit Sensor
020 Paper Feed Sensor 1
021 Paper Feed Sensor 2
022 Registration Sensor
023 Interchange Sensor
024 Duplex: Exit Sensor
025 Duplex: Entrance Sensor
D158/D159/D160/D161/D170
00H
*1: See "Table 1" *1: See "Table 1"
*1: See "Table 1" *1: See "Table 1"
Installed Not installed
Installed Not installed
Paper detected Paper end
Paper detected Paper end
Not at upper limit At upper limit
Not at upper limit At upper limit
*1: See "Table 1" *1: See "Table 1"
Paper detected Paper end
Paper detected Not detected
Lifted
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
Paper detected Not detected
6-23
Using SP Modes
01H
SM