Reassembling The Front Scanner Wire - Ricoh D158 Service Manual

Reassembling the Front Scanner Wire

1. Pass the wire with a ball [A] through the scanner drive pulley as shown below.
2. Position the center ball [A] in the middle of the forked holder.
3. Wind the right end counterclockwise (shown from the machine's front) five times. Wind the left
end clockwise twice.

The two blue marks [A] come together when you have done this. Stick the wire to the
pulley with tape. This lets you easily handle the assembly at the time of installation.
4. Stick the wire to the pulley with tape, so you can easily handle the pulley and wire during
installation.
5. Attach the scanner drive pulley [A] to the shaft and hook the wire onto the left pulley.
D158/D159/D160/D161/D170
Scanner Unit (D158/D159)
4-29 SM