Specifications - BRP Evinrude E-TEC Operator's Manual

PRODUCT INFORMATION

Displacement
Engine Type
Full Throttle Operating Range
(1)
Power
(2)
Idle RPM in Neutral
(2)
Ignition Timing
Emission Control System:
(2)
per SAE J1930
(2)
Fuel Requirements
Oil – Lubricant
Warning Signals
(3)(4)
Battery, Minimum
(2)
Spark Plug
(1) Rated following the standards of ICOMIA 28.83, ISO 3046 and NMMA.
(2) Emission Control Information.
(3) Use a 1000 MCA (800 CCA) battery when operating in temperatures below 0°C (32°F).
(4) Under extraordinary electrical load or environmental conditions, use a 107 amp-hour minimum battery (generally
available in group 29 size).
50

SPECIFICATIONS

200, 225, 250 (3.3 Liter) Models
200.1 cu. in. (3279 cc)
90° V, 6 Cylinder, Two-Cycle, E-TEC
200 HP – 4500 to 5800 RPM
225 HP – 4500 to 5800 RPM
250 HP – 4500 to 5800 RPM
200 HP – 200 HP (147 kw) @ 5150 RPM
225 HP – 225 HP (166 kw) @ 5150 RPM
250 HP – 250 HP (184 kw) @ 5150 RPM
500 ± 50
Controlled by the outboard's EMM
ECM, E-TEC (Engine Control Module, E-TEC)
87 Pump Posted AKI (90 RON) – Refer to FUEL REQUIREMENTS on page 17
Evinrude/Johnson XD100 oil or TC-W3 NMMA-certified oil
– Refer to OIL REQUIREMENTS on page 16
Controlled by the outboard's EMM
675 CCA (845 MCA) 12 volt or
800 CCA (1000 MCA) 12 volt below 0°C (32°F)
Refer to ECI Label