Outboard External Finish; Scratch Repair; Hull Finish; Submerged Outboard - BRP Evinrude E-TEC Operator's Manual

OUTBOARD EXTERNAL FINISH

Periodically, wash the entire boat and outboard with soapy
water and apply a coat of automotive wax. Leave the en-
gine cover in place when washing the outboard.
IMPORTANT: When trailering your outboard, DO NOT
cover the engine with canvas—it will dull the finish of the
outboard's engine covers.

SCRATCH REPAIR

Surface scratches on the upper and lower engine covers
can be painted.
IMPORTANT: Your Dealer has the professional materials
and matching paint colors to properly repair scratches.
See your Dealer to repair any deep scratches or gouges.

HULL FINISH

The condition of your boat's bottom affects performance.
Marine growth or bottom painting may reduce speed and
fuel efficiency.
For maximum performance, keep the boat's running sur-
face clean by rinsing it with fresh water and wiping it dry.
Apply Evinrude anti-corrosion spray to any surface subject
to corrosion, but avoid the anti-corrosion anode(s).

SUBMERGED OUTBOARD

If your outboard has been under water, have it serviced
immediately upon recovery. If immediate service is un-
available, resubmerge it in fresh water to avoid prolonged
exposure to the atmosphere.
After submersion, all boat and engine electrical, fuel, and
oiling systems must be inspected for signs of water intru-
sion. Your Dealer should perform this service.
 STORAGE
43