BRP Evinrude E-TEC Operator's Manual page 42

MAINTENANCE

Concealed Side Mount Control – Typical
2) After outboard runs for about 15 seconds:
For side mount controls, lower fast idle lever.
For binnacle or concealed side mount controls, re-
turn throttle handle to IDLE position.
Outboard continues to run at slow idle speed.
3) After outboard runs for another 15 seconds:
For side mount controls, raise fast idle lever again.
For binnacle or concealed side mount controls, ad-
vance throttle handle to HALF THROTTLE position.
Outboard will accelerate to fast idle speed and fog it-
self.
4) Allow outboard to run until it shuts itself OFF automati-
cally (less than one minute).
Winterization is complete when outboard shuts itself off.
• If the outboard DOES NOT shut itself off, you may
not have used the fast idle lever or button and the out-
board was shifted into gear.
• If the engine exceeds 3000 RPM, the outboard may
have been shifted into gear.
In either event, immediately turn key switch OFF and re-
start the procedure.
Winterization is complete when outboard shuts itself off.
• If the outboard DOES NOT shut itself off, you may
not have properly advanced throttle grip.
• If the engine exceeds 3000 RPM, the outboard may
have been shifted into gear.
In either event, immediately press STOP button to turn
outboard OFF and re-start the procedure.
40
Tiller Control Outboards
1) Advance throttle grip to HALF THROTTLE position.
Start the outboard. Outboard runs at slow idle speed.
Tiller Control – Typical
2) After outboard runs for about 15 seconds, move throttle
grip to IDLE position. Outboard continues to run at slow
idle speed.
3) After outboard runs for another 15 seconds, advance
throttle grip to HALF THROTTLE position. Outboard will
accelerate to fast idle speed and fog itself.
4) Allow outboard to run until it shuts itself OFF automati-
cally (less than one minute).