BRP Evinrude E-TEC Operator's Manual page 24

USING YOUR EVINRUDE E-TEC OUTBOARD

2
1
Single Lever ICON Control
1. Handle – shift and throttle
2. Trim/tilt switch
3. Fast idle (neutral) button
4. RPM Tune button
5. Gear position indicators
2
3
1
4
7
Dual Lever ICON Control
1. Handle – shift and throttle
2. Master Trim/tilt switch
3. Individual engine trim switches
4. Fast idle (neutral) button
5. PowerSync button
6. RPM Tune button
7. Gear position indicators
22
If the following directions are not suitable for your boat's
control, see your Dealer before proceeding.
Shifting
3
With engine running and control handle in NEUTRAL:
Move the control handle fore or aft until it engages the for-
4
ward or reverse gear detent.
5
Speed Control
After gear engagement, move the control handle slowly in
the same direction to increase speed.
Press the RPM + or – button to fine tune engine speed up
or down in 1% increments.
Engine Synchronization
Press the SYNC button to automatically synchronize the
RPM of multiple engines. The SYNC button also transfers
control of all engines to the port lever on the control.
1
5
6
—
ICON Controls
—
ICON Controls
—
ICON Controls