Specifications; Initial Set Up Instructions; List Of Contents; Mounting The Saw - Chicago Electric 96697 Set Up And Operating Instructions Manual

SpeCiFiCationS

120 V~ / 60 Hz / 11.25 A
Motor n 4600/min
0
1-¾ HP
Arbor Diameter 5/8"
Blade Type General Purpose Carbide Tipped
Blade Diameter 10"
Cutting At 90°: 2.95" Deep x 11.8" Wide
Capacity At 45°: 1.57" Deep x 8.26" Wide
Positive Table 0°, 15°, 22.5°, 30° and 45° both
Stops Right and Left
Positive Bevel
0° and 45° Left only
Stops
Blade Tilt 0° - 45° Right and Left Miter
Range 0° - 45° compound
Scale 1° per scale mark
unpaCKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.

list of contents

description
Compound Sliding Miter Saw
Carbide Tipped Blade
Table Extensions
Dust Collection Bag
Wrench
initial Set up
inStruCtionS
read the entire important
SaFetY inFormation section
at the beginning of this manual
SKU 96697 For technical questions, please call 1-800-444-3353.
e105017
Qty
1
1
2
1
1
including all text under
subheadings therein before set
up or use of this product.
warning
From aCCidental
operation:
turn the power Switch of the
tool to its "oFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
attaching the extension Supports
1. Insert the ends of the Extension
Supports into the holes in the sides
of the Base. Tighten the Wing Screws
to hold the Extensions in place. The
upper edge of the Extensions will be
level with the surface of the saw. This
provides a wider base for the work
material to rest on.
attaching the dust Collection Bag
2. The Dust Collection Bag slips over
the Dust Outlet behind the Blade
Housing Assembly. Sawdust created
by cutting is captured in the bag.

mounting the Saw

The Miter Saw must be mounted on
a support before use. This may be
a commercially available support or
home made saw table. There are
bolt holes provided in each of the
to preVent
SeriouS injurY
reV 08f
Page 10