Table of Contents
Advertisement
5-2 9030/40
Diagnostics
Error Code
#6
Error Code
#9
Error Code
#11
BAD CARD DR DEVICE: NNNNN
BAD CARD DR DEVICE: SELECT CODE NN
- Informational message. A hardware failure has been detected (interface card or
mass storage device did not pass the Module Self-Test). The loader continues
searching for an operating system. Possible causes: bad interface card or mass
storage device.
DEVICE NOT READY: NNNNN
VOLUME NOT MOUNTED: NNNNN
MEDIA/DEVICE NOT READY: SELECT CODE NN
- While loading, the media (Volume) was removed from the device (e.g. a floppy
disc was pulled out of a disc drive), the device went offline, or a hardware problem
caused the device to become "not ready".
DMA FA I LED: NNNNN -
Data did not transfer properly from the mass storage device
to the computer. Possible cause: Mass storage device hardware failure or computer
hardware failure.
UNRECOVERABLE DATA: NNNNN
UNRECOVERABLE DATA: SELECT CODE NN
- Part of the operating system is not readable. Possible causes: media failure or
mass storage device hardware failure.
Error Code
END OF IjOLUME: NNNNN
# 12
END OF VOLUME: SELECT CODE NN
Error Code
#13
Error Code
#14
Error Code
#15
Error Code
#16
Error Code
#17
Error Code
#18
Error Code
#19
- Attempt to address or read past the end of a volume. Possible causes: corrupt
system, media failure or mass storage device hardware failure.
CTRLR/UNIT FAULT: NNNNN
CTRLR/UNIT FAULT: SELECT CODE NN
- Hardware passed initial self-test. However. it failed while being used to load the
operating system. Possible causes: computer (interface card) hardware failure or
mass storage device hardware failure.
10 TIMEOUT: NNNNN
10 TIMEOUT: SELECT CODE NN
- Mass storage device failed to respond fast enough while attempting to load from
it. Possible cause: computer hardware failure or mass storage device hardware
failure.
CSSO DEVICE: NNNNN
CSSO DEVICE: SELECT CODE NN
- Indicates a mass storage device hardware failure.
TAPE DEVICE: SELECT CODE NN
-Usually indicates a tape device (HP 7970, HP
7974, HP 7978) hardware failure. Can also indicate a failure on the HP 27110A
HP-IB Interface (or the Internal HP-IB interface). Tape errors covered are: "Com-
mand Rejected", "Interface Busy", "Rewinding", "Tape Runaway", "Data Timing
Error", and "Command Parity Error".
HPIB CARD: NNNNN
HPIB CARD: SELECT CODE NN
- Transaction to the indicated HPIB interface card was terminated due to a prob-
able interface card failure.
BAD 10 BUS: NNNNN
BAD 10 BUS: SELECT COOE NN
- Indicates a computer hardware failure on the computers first lOP.
BAD NI)M: NNNNN
BAD NVM: SELECT CODE NN
- Indicates that Non-Volatile Memory failed its self-test. Possible cause: computer
hardware failure.
Advertisement
Table of Contents
