System Loader Messages - HP 9030 CE Handbook

5-1
Chapter
5
9030/40 Diagnostics
System Loader Messages
Trailer
NNNNN
indicates Rev. A loader select codes.
Example:
Where:
NNNNN
is 21
2~
Remainder
~
2 - 1
=
lOP number Slot number
Trailer
SELECT CODE NN
indicates Rev. B loader select codes; 0 through 7 = 1st lOP,
8 through 15
=
2nd lOP, and 16 through 24
=
3rd lOP.
Messages
Error Code
#24
Error Code
#25
Error Code
#2
Error Code
#4
Error Code
#5
Loade r }(){){ -
Informational message identifying the revision of the system loader.
This message is usually followed by a single line message identifying the operating
system the computer is attempting to load.
T est i n
9"
Me
ITI 0
r)' ••• -
Informational message that follows the "Loader XXX" mes-
sage indicating that the loader is performing memory tests and configUring memory.
This can take up to 15 seconds. (NOT AN ERROR)
L
00
Kin
9"
for S
Y S
t
e
ITI ••• -
Informational message that follows the "Testing Mem-
ory ... " message indicating that the loader is searching for an operating system.
PIe a s e
~I
0 11
n t n ext
\l 0
IlllTl e. -
Informational message. The loader is ready to load
another portion of the operating system. Mount the volume containing an unloaded
portion of the operating system. Volumes may be mounted in any order without
affecting the loading process.
SYSTEM NOT FOUND; WILL RETRY: XXX
SYSTEM NOT FOUND; WILL RETRY IN XXX
- Unable to find an operating system on any mass storage device. The loader will
attempt to find an operating system again in XXX seconds. Possible causes: mass
storage device not powered up, no media in mass storage device, wrong disc in disc
drive, computer or mass storage device hardware failure, media failure, incompati-
ble loader/system revision numbers, etc.
BAD SYSTEM FILE: NNNNN
BAD SYSTEM FILE: SELECT CODE NN
- Operating system loaded. However, an error has been detected in the operating
system code during loading. Possible causes: corrupt system, media failure, mass
storage hardware failure, or computer hardware failure.
INSUFFICIENT USABLE MEMORY: XXXX
NOT ENOUGH USABLE MEMORY; TOTAL IS XXXX
- The amount of usable memory is too small to load the operating system. The
total amount of good memory is "XXXX" bytes. However, the amount of memory
available for the Rev. A operating system is "XXXX" minus 32K bytes. The amount
of memory available for the Rev. B operating system is "XXXX" minus 98 304
bytes. Possible causes: corrupt system or hardware (memory) failure.