Specifications; To Install A Saw Blade - Chicago Electric 91995 Set Up And Operating Instructions Manual

SPECIFICATIONS

Electrical
120 V~ / 60 Hz / 15 A (Start)
Requirements
Speed 5300 RPM (No Load)
Saw Blade (Included) 10" Diameter / 60 Teeth
Arbor Size 5/8" Diameter
4-11/16" x 2-15/16" @ 90°
Crosscut Capacity
4-11/16" x 1-9/16" @ 45°
Blade Tilt Capacity 0° - 45° Left
Positive Stops 0°, 15°, 22.5°, 30°, 45°
Overall Table Size 18-1/8" W x 5-3/8" L x 3-1/8" H
UNPACkINg
When unpacking, check to make sure
all the parts shown on the Parts list near
then end of this manual are included. If
any parts are missing or broken, please
call Harbor Freight Tools at
1-800-444-3353 as soon as possible.
ASSEMBlY INSTRUCTIONS
Note: For additional references to the
parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

To Install A Saw Blade

WARNINg! Prior to performing any
assembly and/or adjustment pro-
cedures, make sure the Power
Cord (102) of the Miter Saw is un-
plugged from its electrical outlet.
Make sure the unit has completely
cooled, and wear heavy-duty work
gloves.
1. When replacing the Saw Blade (56),
make sure the new Saw Blade has a
diameter of 10", an RPM rating of
at least 5,300, and an arbor hole of
5/8" diameter.
SKU 91995
E105017
For technical questions, please call 1-800-444-3353.
SAW
BlADE (56)
ARROW
FIgURE D
2. When installing a Saw Blade (56),
make sure the teeth of the Saw Blade
point downward, and that the direc-
tion of the arrow shown on the Saw
Blade matches the direction of the
arrow shown on the Cover Case (89).
(See Figure D.)
COVER
CASE (89)
ARROW
SAW
TEETH
POINTINg
DOWN
REV 07k, 09d
Page 8