HP Compaq 6710s Maintenance And Service Manual page 85

Remove the wireless antenna cables (2) from the routing channels and clips built into the top cover.
2.
Remove the two Torx T8M2.5×9.0 screws (1) that secure the display assembly to the computer.
3.
NOTE:
cable.
Position the computer with the rear panel toward you.
4.
Remove the four Torx T8M2.5×9.0 screws (1) that secure the display assembly to the computer.
5.
ENWW
The screw removed from the left hinge secures a ground loop (2) for the display panel
Component replacement procedures 77