Notice related to personal injury. caution, without the safety alert symbol, caution is used to address practices not related to personal injury. SKU 96971 for technical questions, please call 1-800-444-3353. Page 2...
Safety equipment such as dust mask, full face shield, non-skid safety shoes, work gloves, or hearing protection used for appropriate conditions will reduce personal injuries. SKU 96971 for technical questions, please call 1-800-444-3353. Page 3...
Page 4
Use of the power tool for operations different from those intended could result in a hazardous situation. SKU 96971 for technical questions, please call 1-800-444-3353. Page 4...
Do not use without guards in place. Do not remove the safety chain. For industrial use, handle, mount, and operate in accordance with ANSI Safety Code B7.1 and OSHA rules. SKU 96971 for technical questions, please call 1-800-444-3353. Page 5...
Page 6
• Properly maintain and inspect to avoid electrical shock. • Any power cord must be properly grounded. Ground Fault Circuit Interrupter (GFCI) should also be implemented – it prevents sustained electrical shock. SKU 96971 for technical questions, please call 1-800-444-3353. Page 6...
The green wire in the cord must be the only wire connected to the tool’s grounding system and must never be attached to an electrically “live” terminal. (see 3-prong plug and outlet.) SKU 96971 for technical questions, please call 1-800-444-3353. Page 7...
If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (see table a.) SKU 96971 for technical questions, please call 1-800-444-3353. Page 8...
Page 9
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes. symbology Double Insulated Volts Alternating Current Canadian Standards Association Amperes No Load Revolutions per Minute n 0 xxxx/min. Underwriters Laboratories, Inc. (RPM) SKU 96971 for technical questions, please call 1-800-444-3353. Page 9...
Cutting Wheel, until the Lock Pin fully engages and holds the Cutting Wheel in place. Continue lock pin cutting (62) wheel (4) to hold the Lock Pin down. REV 10a SKU 96971 for technical questions, please call 1-800-444-3353. Page 10...
Depth Bolt (66) to ad- just the depth of the cut. Do not set the Depth Bolt too low or the surface that the unit is sitting on may be damaged. REV 10a SKU 96971 for technical questions, please call 1-800-444-3353. Page 11...
If the motor performance decreases or stops, it may be necessary to replace the Carbon Brushes (43). SKU 96971 for technical questions, please call 1-800-444-3353. Page 12...
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 96971 for technical questions, please call 1-800-444-3353. Page 13...
If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 96971 for technical questions, please call 1-800-444-3353. Page 16...